24bit/192KHz TUBE DAC DIY KIT - Lampucera1.0 + Lampizator CS8416 + CS4397. It has already follow the Lampucera Oscon modification as well as using ELNA capacitors. On the back of the mainboard, there is a output for the connection of Lampizator (tube output). 24 bit/192KHz input independent digit optical fibre input independent digit coaxial input analogy signal non-balanced output With lots of quality HIFI components The Opamp with all plated components and is easy to replaced. With double-faced(cuprum on one side and foil on the other side)circuit board which is thicker and superior.Recevial chip CS8416 Decode Chip CS4397 Analogy Opamp chip: 5532 S/N ratio 105dB Distortion 0.0005% dynamic range: 117dB Frequency Response 20Hz-30KHz(±0.5dB) analogy output frequency: 2V Imput port: one digital optical fibre input one digital coaxial input Output port: one RCA analogy un-balance output. Power imput voltage: ~110 or 220V 50Hz±10%. The kit contents :as in the pics Main DAC board. Size 85mm(D) X 60mm(W) X 25mm(H). Power supply board Size 80mm(D) X 55mm(W) X 40mm(H).
Hi and Low voltage 3 regulators. 8 power input voltage: ~110 or 220V50Hz±10%. 9 It has a very high input impedance, of about half a meg [500k ohms], and quite a low output impedance, less than 200 ohms. This item is in the category "Consumer Electronics\TV, Video & Home Audio\Home Audio\Receivers & Amplifiers\Amplifiers & Preamps". The seller is "hkaudio1" and is located in this country: HK.