LUXMAN L-504 Integrated amplifier Condition Used, From Japan

  
LUXMAN L-504 Integrated amplifier Condition: Used, From: Japan. Continuous effective output 35W + 35W (8 O, simultaneous operation for both channels). 40W/40W (8 O, single-channel operation). Total harmonic distortion factor 0.03% or Less (8 O, 35W). Cross modulation distortion factor 0.04% or Less (8 O, 35W, 70 hz : 7 khz = 4 : 1). Output bandwidth 5 Hz to 50 kHz -3dB (0.1%).

Frequency characteristic 10 Hz to 60 kHz -1dB. Input sensitivity 480 mv (8 O, 35W). Residual noise 0.5 mV or less. Damping factor 35 (at 8 O Load). Standard output voltage Pre out:480mV.

Maximum output voltage Pre out:4.5V. Output impedance Pre out : Approx.

Rec out : Approximately 100 O. Frequency characteristic Aux1 : 10 Hz to 50 kHz -1dB. Total harmonic distortion factor Aux1 : 0.04% or less (1 kHz, 1 V). Input sensitivity Phono1, 2 : 2.7 mV. Tuner, aux1, 2 : 120 mv. Input impedance Phono1, 2 : 65k O. Tuner, aux1, 2 : 50k O. Signal-to-noise ratio Phono1, 2 : 65 dB or more. Tuner, aux1, 2 : 76 dB or higher. Maximum Allowable Input (1 kHz) Phono : 300 mv (R / M / S). Residual noise Approximately 25 µ V or less. Tone control LUX System NF Type with Bending Point Switching. Low-range bending point : 150 Hz, 300 Hz. High-frequency curve point : 3 kHz, 6 kHz. Attachment Tape Monitor Switch (2 systems). Power consumption 150W (8 O simultaneous load, maximum output). External dimensions Width 450x Height 160x Depth 268 mm. Note only for products that are turned on. Products that do not turn on are not eligible? The power supply for this product is AC100V 50/60Hz.

A transformer may be required in some countries. If it is different from A type, a converter is required. You in areas other than 100V.

If you use the transformer I sell, you can use it in areas other than 100V. If you have any other questions, please contact me. It may not be possible in some areas. (10-30days or more to Other countries). International Buyers - Please Note.